Get Free Quotes in Ontario
We'll review your request and send you options that fit your project.
Cold-climate heat pump installation in Ontario typically costs $5,000-$15,000. Home Renovation Savings rebates can offset up to $2,000 (Enbridge gas-heated homes) or up to $7,500 (homes heated with electricity, oil, propane or wood). HVAC work requires permits in most Ontario municipalities. We review local contractors for licensing and insurance where required, then match you with options that fit your project.
Choose the work you need. Each service has its own page with details and a quote form.
Heat Pump Installation
Cold-climate air-source heat pumps for Ontario winters
See details
Dual-Fuel / Hybrid Systems
Heat pump plus gas furnace backup setups
See details
Ductless Mini-Split
Single and multi-zone ductless heat pumps
See details
HVAC Repair
Furnace, AC, and heat pump service calls
See details
Duct Cleaning & Sealing
Duct cleaning and sealing for better airflow
See details
Smart Thermostat Install
Compatible thermostat installs for gas and heat pumps
See details
Humidifier & HRV
Whole-home humidifiers and heat-recovery ventilators
See details
Boiler Service
Hot water boiler repair and replacement
See details
Heat Pump Water Heater
Efficient heat pump water heaters
See details
Seasonal Tune-Up
Spring AC and fall furnace maintenance visits
See detailsOntario homes face cold winters and hot summers - a properly sized HVAC system is a meaningful investment. Cold-climate heat pumps can replace both your furnace and central AC in one system, and provincial and federal rebates can significantly offset the cost. We connect you with reviewed HVAC contractors who provide accurate load calculations and permit the work properly.
contractor.ca market research, Ontario contractor quotes (2025-2026). Rebates may reduce net cost - see /rebates. Costs vary by home size, equipment brand, and ductwork requirements.
Ontario's Home Renovation Savings Program (HRSP) offers up to $7,500 for qualifying cold-climate heat pump retrofits in homes heated with electricity, oil, propane or wood (up to $2,000 for Enbridge gas-heated homes). The Canada Greener Homes Loan is closed - NRCan says new loan applications cannot be approved. See rebates for current programs and eligibility.
Ready to get quotes for your hvac project in Ontario?
Free for homeowners · No obligationA cold-climate heat pump (CCHP) extracts heat from outdoor air down to -25 degrees Celsius or lower. Modern units maintain efficiency in Ontario winters and can replace both a furnace and central AC in a single system. Ontario rebate programs cover qualifying cold-climate heat pumps - see /rebates for current programs.
A dual-fuel system pairs a heat pump with a gas furnace backup. The heat pump handles mild Ontario weather efficiently; the gas furnace takes over when temperatures drop below the heat pump's cost-effective range. Dual-fuel can be a good fit for homes with existing gas infrastructure in colder rural Ontario locations.
The Ontario Home Renovation Savings Program (HRSP) offers up to $7,500 for qualifying cold-climate heat pump retrofits in homes heated with electricity, oil, propane or wood (up to $2,000 for Enbridge gas-heated homes). The Canada Greener Homes Loan is closed - NRCan says new loan applications cannot be approved. Enbridge gas-heated homes can get up to $2,000 for a cold-climate air-source heat pump through Home Renovation Savings (the older HER+ program is closed). See /rebates for current program details.
A cold-climate heat pump installation in Ontario typically runs $5,000-$15,000 for supply and installation. System size, existing ductwork condition, and whether a full retrofit or add-on system is needed affects cost. Available Home Renovation Savings rebates (up to $7,500 for homes heated with electricity, oil, propane or wood; up to $2,000 for Enbridge gas-heated homes) can meaningfully reduce the net cost.
Spring (April-May) and fall (September-October) are the best times for HVAC work in Ontario. Demand is lower than in peak summer or deep winter, and crews have more scheduling flexibility. If your system fails in summer or winter, emergency replacements are available, but expect premium pricing and tighter timelines.
Ask whether they pull permits for the installation, whether they perform a Manual J load calculation (required to size equipment correctly), how they handle rebate paperwork, and what equipment warranty and labour warranty they provide. A proper load calculation prevents undersized or oversized systems that waste energy.